Prints started to get all wonky about a week ago. I couldn’t figure out the problem. Changed the nozzle, tighten the belts, lubed the z screws, and cleaned the carbon fiber rods. Disassembled the extruder and I didn’t see any clogging, but when I disassembled the hall sensor, I noticed a lot of wear. Then I found a piece of metal inside the extruder that I suspect broke off from the hall sensor somehow. A new extruder arrived yesterday and the X1C is printing like a champ again.

    • GodzillaSpark@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      I noticed that towards the last couple of hundred hours it started to clog/jam a lot more. I thought the gears might be wearing but it looked ok upon visual inspection. I wonder it’s an early warning sign. I only print PLA and PLA+ so nothing abrasive.

      • CmdrShepard@lemmy.one
        link
        fedilink
        English
        arrow-up
        0
        ·
        1 year ago

        What are the replacement costs for this? I’ve heard that Bambu uses all proprietary parts so there’s no buying Chinese knockoffs at a discount.

        • GodzillaSpark@lemmy.worldOP
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          $45. I’m 100% ok with spending $45 after 3000 hours. So far I feel I’m getting good value for my money both with the printer and the parts.

    • ffhein@lemmy.world
      link
      fedilink
      English
      arrow-up
      0
      ·
      1 year ago

      Are there 3rd party replacements for Bambu Labs printers now? I’ve heard people saying a disadvantage with these printers is that you have to buy expensive proprietary parts to repair them if they break

      • GodzillaSpark@lemmy.worldOP
        link
        fedilink
        English
        arrow-up
        0
        arrow-down
        1
        ·
        1 year ago

        At the risk of sounding like a shill, I think bambu components are fairly priced. Nozzles cost $15 a piece and I’ve replaced 2 of them in 3000 hours. The X1C also prints much faster than my old ender 3 so I got a lot of value out of the components.

        I think a more valid argument is if there are few or no 3rd party parts available and Bambu goes out of business. It doesn’t look like we’re going down that road now, but it’s possible to stock up on spare parts to prepare.