nieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 3 months agoWhat is the problem here?programming.devimagemessage-square10linkfedilinkarrow-up15arrow-down10
arrow-up15arrow-down1imageWhat is the problem here?programming.devnieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 3 months agomessage-square10linkfedilink
minus-squareThePantser@sh.itjust.workslinkfedilinkEnglisharrow-up2·3 months agoToo close, level the bed and increase the Z offset until the smoosh is right. Also since it looks like it’s in different places you should do a probe calibration to adjust for uneven surface.
minus-squareJoelk111@lemmy.worldlinkfedilinkEnglisharrow-up1arrow-down1·3 months agoIn some places it’s too close, but in many places (like the top) it’s way too far away.
minus-squareRichard Wonka@slrpnk.netlinkfedilinkEnglisharrow-up1·3 months agoIt may have a probe levelling grid active that’s out of whack.
Too close, level the bed and increase the Z offset until the smoosh is right.
Also since it looks like it’s in different places you should do a probe calibration to adjust for uneven surface.
In some places it’s too close, but in many places (like the top) it’s way too far away.
It may have a probe levelling grid active that’s out of whack.